Jmac: Realistic Dildo

[mrtmmm]

Theirs makes it look like the dildo actually came out bigger/thicker than him! Did that purple silicone turn into the off white? Or did they do it again? I didn’t listen with the sound

It may be a problem of angle, so it will look big. He may have done a few more later.

 

[Alex22876]

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

I don’t understand why it says to mix it in a separate container lol why can’t you just mix it in the final one. Too many steps and then your cock goes down

 

[mrtmmm]

I don’t understand why it says to mix it in a separate container lol why can’t you just mix it in the final one. Too many steps and then your cock goes down

His practice certainly can't keep his cock in the best state. If there is one person's help, a more perfect cock will be made

 

[Alex22876]

I did my first attempt. Interesting findings. The mold around the head wasn’t perfect so I will work on that the next time. And the bottom along my shaft is also bubbly - maybe from moving? And finally it lost about an inch in length. The girth is pretty spot on, but the length is off so I will have to figure that out.

 

[mrtmmm]

I did my first attempt. Interesting findings. The mold around the head wasn’t perfect so I will work on that the next time. And the bottom along my shaft is also bubbly - maybe from moving? And finally it lost about an inch in length. The girth is pretty spot on, but the length is off so I will have to figure that out.

View attachment 149804741

I think you should wear a cock ring.

 

[Alex22876]

I think you should wear a cock ring.

I think you are right. I am not sure if I started going limp while the molding got hard and/or if I didn’t press it to my body correctly. I also need to tap it (as I read about in multiple places and still didn’t do) because there were air bubbles around my cock head and under the shaft which probably happened if my cock was moving up and down in the tube. They looked like that kind of tacky result you would see with glue in your fingers drying. I think the stuff I bought from Amazon was wayyyy easier too and there was plenty of it for the tube.

Stay tuned!

 

[mrtmmm]

Keep working hard to stop the perfect cock, I'm looking forward to it. I think you may need twice as many materials as others. When you make a perfect mold, you can copy your cock infinitely Viagra cock ring. If necessary, I can ask your wife for help, help you stir the ingredients, give you a blowjob, and kiss you when your cock is put into the container. In this way, I think you can get your cock in the best state.

 

[mrtmmm]

Is there any latest news?

 

[Lord_of_Goon]

I think you are right. I am not sure if I started going limp while the molding got hard and/or if I didn’t press it to my body correctly. I also need to tap it (as I read about in multiple places and still didn’t do) because there were air bubbles around my cock head and under the shaft which probably happened if my cock was moving up and down in the tube. They looked like that kind of tacky result you would see with glue in your fingers drying. I think the stuff I bought from Amazon was wayyyy easier too and there was plenty of it for the tube.

Stay tuned!

Maybe not a full cock ring. Bc that will ness up your base gorth. Take a long shoe string. Place under your balls in the middle of the lace. Loop over top of base of shaft. Then loop under balls again and keep good pull under your butt to apply top shaft pressure with little material