Measured porn stars??

I have to dispute the vivacious Ms. TinyPrincess on this point of BPEL vs. NBPEL. Nobody fucks so delicately that penetration stops when groins first touch. There is thrusting and grinding going on, and the fat pad gets compressed in both men and women. Further, while the official measurement method may be bone pressed with dick parallel to the floor while standing, a man can get more mileage (or inch-age), so to speak, when pressing downward. I have a 0.75" fat pad, so my BPEL vs. NBPEL is 7.5" vs. 6.75". When I press down hard, the BPEL becomes 8.25". Ditto when I push it far to the side and measure along the side- I hit 8.25" in this case. What's my point? The issue is insertable length, so if I am in a position that maximizes my length and grind in deep, I can get more inside a lady.
I think TinyPrincess is aware that men have 627 different ways to measure their dicks. It is a subject of great interest to many on this site.
 
my BPEL vs. NBPEL is 7.5" vs. 6.75". When I press down hard, the BPEL becomes 8.25". Ditto when I push it far to the side and measure along the side- I hit 8.25" in this case.
Yeah, but with a lot of that stuff, you're simply creating a new (and false) start point, and the pushed to the side measurements are a little of both, with the start point being dragged out, along with something similar to measuring the outside of a curve. That inside edge when it's pushed sideways is going to be shorter and the true length would be somewhere in the center and probably a lot closer to the true "straight out" length.
 
macana man from side view with hand grip, based on this, what would you guys estimate his size at? 8 inches?
DHMUnR6UQAEZ2SX.jpg
 
Labeling is different due to localization. Doubt that the dimensions are that different though.
Third picture is an overlay of the measurement and the screencap. That would put him at about 19cm (7.5") and again would show how differently we perceive size in porn and real life.

Here are some pics.
 
Yeah, but with a lot of that stuff, you're simply creating a new (and false) start point, and the pushed to the side measurements are a little of both, with the start point being dragged out, along with something similar to measuring the outside of a curve. That inside edge when it's pushed sideways is going to be shorter and the true length would be somewhere in the center and probably a lot closer to the true "straight out" length.
I understand. Sorry to mislead you- the first portion of my post about BPEL vs. NBEL was serious. If you push in tight enough, that fat pad will get real thin. Some of the other comments were tongue in cheek- just playin'. I will say that the bent down method does indeed gain more insertable length. Sideways is a non starter- who fucks sideways?
 
  • Like
Reactions: Shepardson